Assembly - Gardena TCS Li-18 Operating Instructions Manual

Remove the battery:
– before leaving the Pole Pruner unmonitored;
– before removing a blockage;
– before inspecting or cleaning the Pole Pruner or
performing other work;
– when hitting an object. You may only continue to use
the Pole Pruner once you are absolutely sure that the
entire Pole Pruner is in a safe operating condition;
– when the Pole Pruner begins to vibrate unusually
heavily. In this case, it must be inspected immediately.
Excessive vibration can cause injuries.
– before handing over the device to another person.
Maintenance and storage
RISK OF INJURY!
Do not touch the chain.
V When work is finished or interrupted, refit the
protective blade cover.
All nuts and screws must be firmly tightened to ensure
a safe operating condition of the device.
Battery safety
FIRE RISK!
V Never charge the batteries near acids or easily
inflammable materials.
Only use the GARDENA Battery Charger supplied.
The use of other battery chargers may damage the
batteries irreparably and even cause a fire.

3. Assembly

Installing the telescopic handle:
ß
M
2
Installing the shoulder strap:
l
18
The Pole Pruner, battery, battery charger, chain, bar, protective
cover complete with Allen key and the operating instructions are
included in the scope of delivery.
3
1. Slide telescopic pipe
stop position. Ensure that the two markings
2. Tighten the grey nut
1. Widen the belt clip
screw
k
2. Engage the shoulder strap clasp
d
3. Adjust the shoulder strap to the desired length by using the
quick strap fastener.
CAUTION!
The supplied shoulder strap must be used.
k
RISK OF EXPLOSION!
V Protect battery from heat and fire.
Do not leave on radiators or expose
to strong sunshine for long periods.
Do not use the battery charger outdoors.
V Protect the the battery charger from damp or wet
areas.
Only use the battery in ambient temperatures of
between 0 °C and 40 °C. A non-functioning battery
must be disposed of cor rectly. It may not be sent via
post. For further details, please contact your local
disposal companies. The charging cable should be
checked regularly for signs of damage or ageing (brittle-
ness) and may only be used if it is in perfect condition.
The charger unit provided may only be used to charge
the rechargeable batteries supplied with the unit.
Non-rechargeable batteries must not be charged with
this battery charger (danger of fire). After charging,
disconnect the charger from the mains and from the
battery. Only charge battery between 0 – 45 °C. After
heavy duty service allow battery to cool down first.
Storage
The Pole Pruner must not be exposed to direct
sunlight while in storage.
Do not store the Pole Pruner in places with static
electricity.
1
into the motor unit
2
.
3
and fasten it onto the beam using the
d
.
ß
M
2 3
until you reach the
1
face each other.
ß
M
to the belt clip .
l d