Table of Contents
Advertisement
Pull the cable through the steeve and then secure the steeve to the flange. Fix the M4 bolt into place.
Please note, if the speed dome is installed in an outdoor environment, you need to paste enough Teflon tape at
the top screw thread of the steeve and then turn the steeve onto the flange firmly. Please paste the silica gel on
the steeve connection surface to waterproof it. See Figure 5-4.
Draw 4 points, on to the installation wall, which line up with the screw holes wall mount bracket. Then you can
drill four holes and insert the expansion bolts (not provided). Use four hex bolts and flat washer to fix the bracket
in the expansion bolts. See Figure 5-5.
© Copyright Qvis® All documentation rights reserved.
Figure 5-2
Figure 5-3
Silica gel
Teflon tape
Silica gel
Figure 5-4
Connect to flange
M4 bolt
17
Advertisement
Table of Contents
