Install The Speed Dome - Qvis APOHD-PTZ20 User Manual

function composite cable coming from the quick installation speed dome. Paste the insulating tape in the
connection position to make sure everything is waterproof. See Figure 2-5.
Note: The video port is covered by the high ratio heat shrinked tube. After you have completed the cable
connection, please heat the tube to make sure the video port is damp proof and water proof.

2.2.3 Install the speed dome

1. After you complete the above steps, please pull the integration cable and multiple-function composite
cable through to the wall mount bracket.
2. Line up the straight edge, of the internal enclosure within the quick installation speed dome, to the
straight edge of the quick installation port, and then slowly push the speed dome to the bottom of the
port. Use your hands to turn the three stainless steel screws, on the quick installation port, in to the
groove of the speed dome's internal enclosure. Turn the screws on the straight edge of the quick
installation port to the Ф6.5 hole of the speed dome's internal enclosure. Use the inner hex tool to fix
these three screws. Installation should now be complete. See Figure 2-6.
© Copyright Qvis® All documentation rights reserved.
Figure 2-5
7