Install The Transparent Cover - Qvis APOHD-PTZ20 User Manual

2.2.2 Install the transparent cover

1. Firstly you need to check the steel wire of the bracket to see if it is firmly secure or not.
2. Please line up the captive screws to the quadrate groove of the bracket and then push the bracket into
the internal enclosure. Fix these two captive screws in to place. See Figure 2-3.
3. Now you can install the quick installation port. Please twist the Teflon tape around the screw thread of
the quick installation port and turn it into the screw thread of the wall mount bracket. Use M4 stainless
screws to secure firmly. See Figure 2-4.
4. Now you can begin the cable connection.
5. Connect the steel wire of the quick installation cover to the hook on the quick installation port.
6. Connect the reserved integration cable from the wall mount bracket to the corresponding power cable,
video output cable, RS485 control cable and alarm input/output port (if necessary) of the multiple-
© Copyright Qvis® All documentation rights reserved.
Figure 2-3
Figure 2-4
6