Attach Ring To Finger - Honeywell HX3 User Manual

Attach Ring to Finger

The ring finger loop is located under the ring assembly.
Pull gently on the end of the finger loop strap to separate the hook and loop fabric. Slide your finger into the opened loop under
the ring scanner. Grasp the end of the finger loop strap and loosen, then tighten, the finger strap until the ring scanner is
comfortably snug and the scan aperture is secured in the desired location.
The ring scanner has a built-in quick disconnect designed for occasional safety hazards. It is not intended for frequent, normal
removal of the ring scanner from the hand.
Note: Do not touch, push against or brace your finger on the scan aperture at any time.
1. Slide finger into opened loop
2. Remove shipping film on scan aperture before first
scan
3. Tighten the finger loop strap
4. Ring worn on left hand
5. Ring worn on right hand
2-5