Connect / Disconnect Battery; Connect Battery; Disconnect Battery - Honeywell HX3 User Manual

Connect / Disconnect Battery

Note: The HX3 will not function unless a battery is securely tethered. When the HX3 is placed in a powered cradle, the
connection between the tethered battery and the HX3 is broken, and the HX3 is receiving power through the cradle-
HX3 connector.
Be sure to place the unit in Suspend Mode before removing the battery. Failing to properly place the device in Suspend mode
will result in a loss of all unsaved data.
An HX3 will retain data, while the main battery is removed and replaced with a fully charged main battery, for 5 minutes.
Important: When the internal battery power is Low or Very Low connect the AC adapter to the HX3 before replacing the main
battery.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the battery is not connected to
the HX3, any dust or moisture that enters the battery well or connector may transfer to the battery/well terminals,
potentially causing damage.
Warning. Only use Honeywell batteries as replacements:

Connect Battery

To connect the main battery, complete the following steps:
1. Hold the battery with one hand with the connector facing up.
2. With the other hand, press the battery cable connector down onto the battery connector, making sure the connectors
line up.
The HX3 draws power from the battery immediately upon successful connection.
Check battery status by tapping the Start > Settings > Control Panel > Battery icon. Main battery level, internal battery
level, status and other details are displayed.

Disconnect Battery

To remove the battery cable from the HX3, first press downward on the Retaining Clip, then pinch and pull the cable connector
straight up and away from the HX3. Do not use a metal object, or extreme force, to remove the cable connector from the HX3.
Re-connect cables and reassemble the HX3 body-worn components.
Place the discharged battery pack in a powered battery charger.
2-9