Operation - Webb WER21HW Operator's Manual

OPERATION

Brake lever - must be held down to the handle to start the engine. Release to stop the engine.
Starter handle - used for starting the engine.
Drive control lever - used to engage the self-propel system.
USE YOUR LAWNMOWER ENGINE SPEED
The engine speed was set at the factory for optimum performance. Speed is not adjustable.
DRIVE CONTROL
Self-propelling is controlled by holding the operator presence control bar down to the handle and
pushing the drive control lever forward until it clicks; then releasing the lever.
Forward motion will stop when the operator presence control bar is released.
To stop forward motion without stopping the engine release the operator presence control bar slightly until
the drive control disengages. Hold the operator presence control bar down against handle to continue
mowing without self-propelling.
ADJUST CUTTING HEIGHT
Raise wheels for the highest cut and lower wheels for a lower cut; adjust cutting height to suit your
requirements. Medium position is best for most lawns.
Drive lever
9
Push handle
Operator Presence
Control Bar