Webb WER21HW Operator's Manual And Parts List
  1. Manuals
  2. Brands
  3. Webb Manuals
  4. Lawn Mower
  5. WER21HW
  6. Operator's manual and parts list

Webb WER21HW Operator's Manual And Parts List

Petrol lawn mower
Hide thumbs Also See for WER21HW:
Table of Contents

Advertisement

Quick Links

See also: Operator's Manual
OPERATOR'S MANUAL AND PARTS LIST
PETROL LAWNMOWER
WER21HW
Spares & Support: 01793 333212
www.webblawnmowers.co.uk
Before use please read & understand this manual, paying particular attention to
the safety instructions.
04/11/2013

Advertisement

Table of Contents
loading

Related Manuals for Webb WER21HW

Summary of Contents for Webb WER21HW

  • Page 1 OPERATOR’S MANUAL AND PARTS LIST PETROL LAWNMOWER WER21HW Spares & Support: 01793 333212 www.webblawnmowers.co.uk Before use please read & understand this manual, paying particular attention to the safety instructions. 04/11/2013...

  • Page 3: Table Of Contents

    To ensure that you get the best results from your Petrol Lawnmower please read all of these safety and operating instructions carefully before using this product. TABLE OF CONTENTS PRODUCT SPECIFICATION Product Specifications…..2 Model number Safety Rules…………………..3 WER21HW high wheel self propelled type Assembly/Pre-Operation..5 Petrol engine 190CC Operation……………………..9 Engine speed 3000/min Maintenance…………………11...

  • Page 4: Safety Rules

    Before Use a) Read the instructions carefully: Be familiar with the controls and the proper use of the equipment. b) Never allow children or people unfamiliar with these instructions to use the lawnmower. Local regulations may restrict the age of the operator. c) Never mow while people, especially children, or pets are nearby.
  • Page 5 m) Disengage all blade and drive clutches before starting the engine. n) Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade(s). o) Do not tilt the lawnmower when starting the engine or switching on the motor. p) Do not start the engine when standing in front of the discharge chute.

  • Page 6: Assembly/Pre-Operation

    SYMBOLS The following symbols can be found on the machine to remind you of the care and attention that are required during use. The symbols mean: DANGER – Rotating Warning! Keep hands Read the blades. Keep hands and feet clear of the Operator’s and feet out of cutting deck when the...
  • Page 7 INSTALL ATTACHMENTS Please note your lawn mower may have been shipped with the mulching plug already fitted under the rear grassbox flap. The mower has four different operating modes. 1. Collecting: • Ensure that the side cover is closed. • Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the mower.

  • Page 10: Operation

    OPERATION Drive lever Push handle Operator Presence Control Bar Brake lever - must be held down to the handle to start the engine. Release to stop the engine. Starter handle - used for starting the engine. Drive control lever - used to engage the self-propel system. USE YOUR LAWNMOWER ENGINE SPEED The engine speed was set at the factory for optimum performance.
  • Page 11 BEFORE STARTING THE ENGINE ADD OIL Before each use the oil level must be checked and if necessary topped up with SAE30 engine oil. OIL FILLER CAP/DIPSTICK UPPER LIMIT LOWER LIMIT Your lawnmower is shipped without oil in the engine. CAUTION: DO NOT overfill the engine with oil, or it will smoke heavily from the muffler on startup.

  • Page 12: Maintenance

    START THE ENGINE To start the engine, first check that the spark plug is tightened and that the machine is filled with sufficient oil and petrol. NOTE: Due to the protective coating on the engine, a small amount of smoke may be present during the first use of the product and should be considered normal.
  • Page 13 CLEANING Carefully clean the machine with water after each cut; remove the grass debris and mud accumulated inside the chassis to avoid their drying and thus making the next start-up difficult. The paintwork on the inside of the chassis may peel off in time due to the abrasive action of the cut grass; in this case, intervene promptly by touching up the paintwork using a rustproof paint to prevent the formation of rust that would lead to corrosion of the metal.
  • Page 14 Spark Plug Once the engine has cooled, remove the spark plug and clean the plug with a wire brush. Using a feeler gauge, set the gap to 0.75 mm (0.030”). Refit the spark plug taking care not to overtighten it. Air Filter Unclip the air filter cover and remove the paper filter element.

  • Page 15: Maintenance Schedule

    DRAINING THE FUEL TANK AND CARBURETTOR 1. Place an approved petrol container below the carburettor, and use a funnel to avoid spilling fuel. 2. Remove the drain bolt, and then move the fuel valve lever to the ON position. 3. After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten the drain bolt securely.

  • Page 16: Trouble Shooting

    TROUBLE SHOOTING ENGINE WILL NOT START Possible Cause Correction 1. Check fuel. Out of fuel. Refuel. Bad fuel: engine stored without Drain the fuel tank and carburettor draining petrol, or refuelled with (p.14). Refuel with fresh petrol. bad petrol 2. Remove and inspect the spark Spark plug faulty, fouled, or Replace the spark plug (p.13).

  • Page 17: Service

    THE ENVIRONMENT In order to protect the environment, we recommend that the following points should be given special consideration: Always use pure unleaded petrol. Always use a funnel and/or a petrol can with a level control to avoid spillage when refilling the fuel tank.
  • Page 18 Parts Diagram...
  • Page 19 Parts List REF PART NO DESCRIPTION QTY REF PART NO DESCRIPTION WE104-1 Form Cover 39 WE104-39 V Belt WE104-2 Upper Handle 40 WE104-40 BS675 engine WE104-3 OPC Lever 41 WE104-41 Rear Discharge Cover Spring WE104-4 Drive Lever 42 WE104-42 Rear Discharge Cover WE104-5 Hex Bolt M6x35 43 WE104-43...
  • Page 20 REF PART NO DESCRIPTION QTY REF PART NO DESCRIPTION 77 WE104-77 Right Press Board for Belt Cover 88 WE104-88 8" Front Wheel Outer Cover 78 WE104-78 Bag Cover Ventilation 89 WE104-89 8" Front Wheel 79 WE104-79 Handle Cap 90 WE104-90 8"...

  • Page 21: Ec Declaration Of Conformity

    EC Declaration of Conformity We, Importer Handy Distribution SN3 4NS Declare that the product Model: WER21HW Complies with the following directives: 2006/42/EC- Machinery Directive 2004/108/EC- Electromagnetic Compatibility Directive 2000/14/EC amended by 2005/88/EC- Noise Emission in the Environment by Equipment for Use Outdoors Directive.
  • Page 22 • • • • & & • • • • & & • • • •...

Table of Contents