Advertisement
Quick Links
WERR16
OPERATOR'S MANUAL AND PARTS LIST
Self Propelled 16 Inch
Rear Roller Petrol Lawnmower
Spares & Support: 01793 333212 -
www.webblawnmowers.co.uk
Before use, please read & understand this manual, paying particular attention
to the safety instructions.
193839001
30/12/2014
Advertisement
Related Manuals for Webb WERR16
Summary of Contents for Webb WERR16
- Page 1 WERR16 OPERATOR’S MANUAL AND PARTS LIST Self Propelled 16 Inch Rear Roller Petrol Lawnmower Spares & Support: 01793 333212 - www.webblawnmowers.co.uk Before use, please read & understand this manual, paying particular attention to the safety instructions. 193839001 30/12/2014...
- Page 3 Start/Stop Engine Maintenance Trouble Shooting Parts Drawing & List Warranty Terms & Conditions EC Declaration of Conformity Warranty Registration PRODUCT SPECIFICATION Model Number WERR16 Product Number 193811001 Petrol Engine Briggs & Stratton 500E Series Engine Cubic Capacity(cc) 140cc Engine Speed 2800rpm...
- Page 4 PRODUCT HIGHLIGHTS Brake Lever Drive Lever Triangle Knob Fuel Cap Starter Handle B&S 500E Series Grass Collector Rear Roller Exhaust Muffler Height Adjustment Lever IMPORTANT: Failure to observe the following safety instructions could result in serious injury. WARNING: In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect the spark plug lead.
- Page 5 GENERAL OPERATION AND SAFETY RULES Read the instructions carefully. Be familiar with the controls and the proper use of the equipment. Do not put your hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.
- Page 6 Before using, always visually inspect to ensure that the blade, blade bolts and cutter assembly are not worn or damaged. Replace worn or damaged blades and bolts in sets to preserve balance. Never tamper with safety devices. Regularly check that they are operating properly. ...
- Page 7 ASSEMBLY/PRE-OPERATION Read this instruction manual in its entirety before you assemble or operate your new lawnmower. Your new lawnmower has been assembled and tested at the factory. Roll the lawnmower out of the carton and check the carton thoroughly for additional loose parts. IMPORTANT: The lawnmower is shipped WITHOUT OIL OR PETROL in the engine.
- Page 8 INSTALL ATTACHMENTS The mower has three different operating modes. 1. Collecting: Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the mower. Lower the flap to lock the grassbox in position. ...
- Page 9 OPERATION DRIVE CONTROL (Model: WERR16) The drive is controlled by holding the Operator Presence Control bar up to the push handle and pulling the Drive Control lever back towards the handle. Forward motion will stop when the Operator Presence Control bar is released. To stop forward motion without stopping the engine release the Drive Control lever until the drive control disengages and hold the Operator Presence Control bar up against handle to continue mowing without the drive.
- Page 10 BEFORE STARTING ENGINE ADD OIL & PETROL Check the engine manufacturers Instruction Manual, to ensure you do not invalidate the engine warranty, before undertaking any actions. YOUR LAWNMOWER IS SHIPPED WITHOUT OIL OR PETROL IN THE ENGINE. Before each subsequent use, the oil level must be checked and if necessary topped up with SAE30 engine oil.
- Page 11 START ENGINE To start the engine, first make sure that the spark plug is positioned securely and the engine has been filled with sufficient oil and petrol. NOTE: Due to protective coatings within the engine, a small amount of smoke may be present during the initial use of the machine and should be considered normal.
- Page 12 MAINTENANCE IMPORTANT - Regular, careful maintenance is essential for keeping the safety level and original performance of the machine unchanged over time. 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Regular maintenance is essential for safety and performance.
- Page 13 CHANGING BLADES Empty the oil tank before removing the blade. To replace the blade, undo the blade securing bolt. This will be very tight and it is recommended that you wear protective gloves, due to the blade being very sharp. Blade Adaptor Blade Blade Washer...
- Page 14 SPARK PLUG Once the engine has cooled, remove the spark plug and clean with a wire brush. Using a feeler gauge, set the gap to (0.7-0.8mm) or (0.028-0.031”). Refit the spark plug taking care not to over tighten. AIR FILTER Unclip the air filter cover and remove the sponge filter element.
- Page 15 MAINTENANCE SCHEDULE REGULAR SERVICE PERIOD(4) Every Every First Every 3 Every 6 Before Year Month Months Months ITEM Each Years Perform at every indicated month or or 250 5 Hrs 25 Hrs 50 Hrs operating hour interval, whichever comes first. Check Engine oil Replace...
- Page 16 SERVICING We recommend that you take the machine to an authorised service dealer for annual servicing, maintenance and inspection of safety equipment. For service and spare parts, please contact your nearest approved service dealer, who can be found by visiting www.webblawnmowers.couk. STORAGE ...
- Page 17 PARTS DIAGRAM...
- Page 18 PARTS LIST - 1 Item No Handy Part No. Handy Description WE119-1 Top Handle WE119-2 Foam Pipe WE119-3 Self-Propelled Lever WE119-4 Brake Lever WE119-5 Brake Lever Foam Pipe WE119-6 Self-Propelled Lever Foam Pipe WE119-7 Left Handle Cover Inner WE119-8 Left Handle Cover Outer WE113-9 Lock Nut M6/8.8 WE119-9...
- Page 19 PARTS LIST - 2 Item No Handy Part No. Handy Description WE119-29 Pin 5.3x16 WE119-30 Long Key WE119-31 WE119-32 Roller Sleeve WE114-8 Bearing 6001RS WE119-33 Chain Big Gear WE119-34 Chain WE119-35 Chain Small Gear WE119-36 Chain Cover WE119-37 Right Rear Bracket WE113-37 Hex Screws M6x10 WE119-38...
- Page 20 PARTS LIST – 3 Item No Handy Part No. Handy Description WE119-62 Height Adjustment Rod WE119-63 Height Adjustment Spring WE119-64 Hex Bolt M6x20 WE119-65 Rear Roller Rubber Cover WE119-66 Hex Lock Nut M5 WE119-67 Hex Flange Bolt M5x10 WE113-28 Cable Stopper WE119-68 Hex Flange Bolt M6x35 QG112-14...
- Page 21 2. Period of Warranty All Webb, Handy Pro (Brushcutter & Long Handle Hedgecutter only) and Sanli domestic products (a) 2 years from the original date of sale to the first domestic user.
- Page 22 GJ HANDY & CO LTD USER WARRANTY POLICY 3. Not covered by this warranty The warranty policy does not cover any depreciation or damages caused by ordinary wear, rusting or corrosion, lack of correct maintenance or operation, misuse, abuse, lack of transportation or accident. The warranty policy does not cover any costs necessary for the standard periodic maintenance services instructed by the operators manual, or service parts replacement which would include oil, filters, tyres, belts, brake linings, fuses,...
- Page 23 EC Declaration of Conformity We, Importer Handy Distribution SN3 5HY Declare that the product Model: WERR16 Complies with the following directives: 2006/42/EC- Machinery Directive 2000/14/EC amended by 2005/88/EC- Noise Emission in the Environment by Equipment Use Outdoors Directive. The conformity assessment procedure followed was in accordance with...
- Page 24 & & & &...
- Page 27 Webb Lawnmowers, c/o Handy Distribution, Dorcan Industrial Estate Swindon, SN3 5HY, United Kingdom Tel: +44 (0) 1793 333220, Fax: +44 (0) 1793 834461 Email: customerservice@webblawnmowers.co.uk www.webblawnmowers.co.uk Warranty Registration Form Please go to www.webblawnmowers.co.uk and complete the registration for your machine, alternatively please fill in this form and return to the address above.
- Page 28 Webb Lawnmowers, c/o Handy Distribution, Dorcan Industrial Estate Swindon, SN3 5HY, United Kingdom ------------------------------------------------------------------------------------------------------------------------...