Webb WER21HW Operator's Manual page 7

INSTALL ATTACHMENTS
Please note your lawn mower may have been shipped with the mulching plug already fitted under the rear
grassbox flap.
The mower has four different operating modes.
1. Collecting:
• Ensure that the side cover is closed.
• Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the
mower.
• Lower the flap to lock the grassbox in position.
• When the box is full, the grass will be visible through the viewing window in the top of the box.
• Stop the engine before emptying the grassbox.
2. Rear Discharge:
• Ensure that the side cover is closed.
• With the grassbox removed and the rear flap in the down position, the mower will cut and discharge the
grass from the rear of the machine.
3. Side Discharge:
• Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
• Lift the cover on the side of the mower and attach the side discharge chute as shown in the diagram.
• The mower will now eject grass from the side discharge chute.
4. Mulching:
• Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
• Ensure that the side cover is in the closed position (with the discharge chute removed).
• The mower will now recycle the chopped grass into the lawn surface.
• To mulch efficiently only cut one third of the length of the grass.
ASSEMBLE HANDLE
Fit the Lower Handle to the frame of the lawnmower.
Insert 1x Square Neck Bolt M8x30 into the lower hole of the handle and frame from the outside.
Once through, add the Flat Washer and Small Triangle Knob with M8 Hex Nut, tighten until they are
secure.
Insert a Hex Bolt M8x16 into the second lower handle fixing and frame hole from the outside.
Once through, add a Lock Nut M8/8.8 and tighten.
Fit the Upper Handle to the Lower Handle.
There are two holes in the Upper Handle, insert the Carriage Bolt M8x50 from the inside through the
Lower Handle and your selected hole in the Upper Handle to assemble the handle at your chosen height.
Once through, fit a Flat Washer and Large Triangle Knob with an M8 Hex Nut, tighten until they are
secure.
To avoid damage during the transport process, the drive and brake cables for your machine may not be
fitted to their appropriate handle bar.
The front cable is the brake cable, which is to be fitted to the front lever on your machine, this is the
Operator Presence Control Lever (OPC). The cable at the rear is your drive cable, which is to be fitted to
the rear lever, which is your Drive Lever.
6