Assembly/Pre-Operation - Webb WER18HP Operator's Manual And Parts List

Never tamper with safety devices. Regularly check that they are operating properly.
Keep the machine free of grass, leaves, or other debris build-up. Clean oil or fuel spillage. Allow the
machine to cool before storing.
Exercise extreme caution when changing direction on slopes.
Never attempt to make wheel height adjustments while the engine is running.
Grass catcher components are subject to wear, damage, and deterioration, which could expose
moving parts or allow objects to be thrown. Frequently check components and replace with the
manufacturer's recommended parts, when necessary.
The mower blades are extremely sharp. Wrap the blade, wear gloves, and use extra caution when
servicing them.
Do not change the engine governor setting or over-rev the engine.
Stop the engine if the lawnmower has to be tilted for transportation when crossing surfaces other than
grass, and when transporting the lawnmower to and from the area to be mowed.
Disengage the drive clutch before starting the engine.
Start the engine carefully according to the instructions, with your feet well away from the blade.
Do not tilt the lawnmower when starting the engine or cutting.
Do not start the engine when standing in front of the discharge chute.
Never pick up or carry a lawnmower while the engine is running.

ASSEMBLY/PRE-OPERATION

Read this instruction manual in its entirety before you assemble or operate your new lawnmower.
IMPORTANT: The lawnmower is shipped WITHOUT OIL OR PETROL in the engine.
Your new lawnmower has been assembled and tested at the factory.
Roll the lawnmower out of the carton and check the carton thoroughly for additional loose parts.
INSTALL ATTACHMENTS
Your lawnmower was shipped ready to be used as a rear bag mower.
The mower has three different operating modes.
1. Collecting:
• Fit the grassbox by lifting the rear flap on the mower and hook the front of the box to the shaft on the
mower.
• Lower the flap to lock the grassbox in position.
• When the box is full, the grass will be visible through the viewing window in the top of the box.
• Stop the engine before emptying the grassbox.
2. Rear Discharge:
• With the grassbox removed and the rear flap in the down position, the mower will cut and discharge the
grass from the rear of the machine.
3. Mulching:
• Fit the mulch plug to the rear discharge opening of the mower and close the rear flap.
• The mower will now recycle the chopped grass into the lawn surface.
• To mulch efficiently only cut one third of the length of the grass.
3