13-2.
INDOOR UNIT (setting by wireless remote controller)
The function settings of the control of the indoor unit can be changed by this procedure
●
according to the installation conditions. Incorrect settings can cause the indoor unit to
malfunction.
After the power is turned on, perform the "FUNCTION SETTING" according to the
●
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
●
Number.
Settings will not be changed if disable numbers or setting numbers are selected.
●
PREPARATION
(1) Turn on the power of the Outdoor unit.
Before turning on the power of the indoor units, make sure the piping air-tight test and vacuuming have been
conducted.
Also check again to make sure no wiring mistakes were made before turning on the power.
Outdoor unit
Breaker ON
- (01-148) -
Indoor
units