Indoor Unit (Setting By Simple Remote Controller) - Fujitsu AU*G07LVLA Technical Manual

13-4.

INDOOR UNIT (setting by simple remote controller)

The function settings of the control of the indoor unit can be changed by this procedure
●
„
according to the installation conditions. Incorrect settings can cause the indoor unit to
malfunction.
After the power is turned on, perform the "FUNCTION SETTING" according to the
●
„
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number and Setting
●
„
Number.
Settings will not be changed if disable numbers or setting numbers are selected.
●
„
This function cannot be used on secondary units.
●
„
„ „
PREPARATION
(1) Turn on the power to the Outdoor unit.
● Before turning on the power indoor units, make sure the piping air-tight test and vacuuming have been
conducted.
● Also check again to make sure no wiring mistakes were made before turning on the power.
Outdoor unit
Breaker ON
- (01-171) -
Indoor
units