Figure 143: Gxv3240 Connect To Wi-Fi; Add Wi-Fi Networks - Grandstream Networks GXV3240 User Manual

ADD WI-FI NETWORKS

1. Once Wi-Fi is turned on, GXV3240 will automatically start the scanning within the range.
2. Go to GXV3240's Settings.
3. Touch Wireless & Network.
4. Touch Wi-Fi Settings.
5. A list of Wi-Fi networks will be displayed as scanning result. Tap on the SSID and enter the correct
password information to connect to the selected Wi-Fi network.
6. The phone will start connecting to the Wi-Fi. The status bar will show Wi-Fi signal strength.
7. Once it's added and the password is remembered, the GXV3240 will connect to it again when the
SSID is within the range.
8. The previous steps allow the GXV3240 to connect the WiFi network with DHCP setting by default. If it
needs to connected the WiFi with static IP or PPPoE setting, please scroll down the setting window
and tap to check the "Show advanced options". Then the window will show up the IP settings at the
bottom. If the Static is selected, the system will require end user to input IP address, Gateway,
Network prefix length and DNS 1 and DNS 2 addresses. If the PPPoE is selected, the system will
require end user to input PPPoE account ID and password.
Firmware Version 1.0.3.6

Figure 143: GXV3240 Connect to Wi-Fi

GXV3240 User Guide Page 154 of 161