Table of Contents
Advertisement
S
S
UPER
ERVER 2027GR-TRFH/2027GR-TRFHT User's Manual
6-5
Expansion Card Setup
The SC218G supports the following PCI-Express expansion cards and an expan-
sion card bracket:
•
One low-profi le PCI-E 3.0 (x8) card (in x16 slot)
Installing a Full-Height, Full-Length Expansion Card
1. Disconnect the chassis from any power source.
2. Confi rm that you have the correct expansion card, riser card and expansion
card bracket for the SC218G chassis.
3. Remove the PCI-E slot covers at the rear of the chassis.
4. Insert the expansion card into the bracket and secure it with the screw pro-
vided. Note: cards up to 10.5" in length are supported.
5. Insert the expansion card into the riser card.
6. Simultaneously place the expansion card bracket into the chassis as shown
on the following page, while inserting the riser card into its appropriate slot on
the serverboard.
7. Secure the expansion card bracket to the chassis with the three screws
provided.
Figure 6-9. Rear Expansion Card Slots
Low-Profi le PCI-E Slots
Standard Size PCI-E Slots
6-8
Advertisement
Table of Contents
