Installation Of The Toughswitch Poe Carrier; Mounting In A Rack; Connecting The Power Cords - Ubiquiti TouchSwitch TS-5-POE User Manual

TOUGHSwitch PoE User Guide
™
Installation of the
TOUGHSwitch PoE CARRIER
Installation Requirements
• Phillips and flathead screwdrivers
• Standard‑sized, 19‑inch wide rack with a minimum
height of 1U available
• For indoor applications, use Category 5 (or above) UTP
cabling approved for indoor use.
• For outdoor applications, shielded Category 5 (or
above) cabling should be used for all wired Ethernet
connections and should be grounded through the
AC ground of the power supply. We recommend that
you protect your outdoor networks from the most
brutal environments and devastating ESD attacks with
industrial‑grade shielded Ethernet cable from Ubiquiti
Networks . For more details, visit:
™
www.ubnt.com/toughcable
Note: Although the cabling can be located
outdoors, the TOUGHSwitch itself should be
housed inside a protective enclosure.

Connecting the Power Cords

1. Connect the Power Cord to the Power port of each
TOUGHSwitch.
Ubiquiti Networks, Inc.

Mounting in a Rack

1. Attach the TOUGHSwitch PoE CARRIER to the rack
using the four 10-32 x 5/8 Phillips Screws. (If the rack has
square slots, then use the 10-32 x 5/8 Cage Nuts with the
Phillips Screws.)
Note: Keep 20 mm of clearance next to the
ventilation holes for adequate airflow.
2. Attach the top portion of the faceplate at a slight angle,
and then snap on the bottom portion. Secure the
faceplate to the TOUGHSwitch PoE CARRIER using the
two M3x8 Flathead Screws.
Connecting Power
1. Connect the other end of each Power Cord to a power
outlet.
Chapter 2: Installation
9