Introduction Introduction Thank you for purchasing the Ubiquiti Networks TOUGHSwitch ™ PoE, model TS-5-POE. It is part of the TOUGHSwitch series: Name Model Description TOUGHSwitch PoE TS-5-POE 5-port managed switch featuring 24V PoE TOUGHSwitch PoE PRO TS-8-PRO 8-port managed switch...
TOUGHSwitch PoE Quick Start Guide ™ Hardware Back Panel Grounding Grounding Ventilation Holes Power Slot Slot Front Panel Ports Management Reset Interface Description 10/100 Mbps port for management. Traffic between the Management port and numbered ports will Management be limited to 10/100 Mbps and, under heavy load, may cause performance degradation of the TOUGHSwitch.
Hardware Front Panel LEDs Link/Act Speed/Link/Act State Status No Link After bootup, the LED indicates power. After an initial link is established, the LED indicates a 10/100 Mbps connection. If the Link/Act Amber link terminates, the LED turns off until a link is re-established. If the unit reboots, the LED will again indicate power until a link is established.
TOUGHSwitch PoE Quick Start Guide ™ Hardware Installation Mount the TOUGHSwitch on a wall or place it on a bench top. Note: Keep 20 mm of clearance next to the ventilation holes for adequate airflow. Installation Requirements • Drill, 6 mm drill bit, and Phillips screwdriver (wall-mounting) • For outdoor applications, shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the power supply.
Page 7
Hardware Installation 4. Position the Wall-Mount Slots of the TOUGHSwitch over the screw heads on the wall. Then slide the TOUGHSwitch to the left to lock it into place. Grounding the TOUGHSwitch (Optional) The TOUGHSwitch is grounded through the Power Adapter; however, you can add optional ESD grounding for enhanced ESD protection.
TOUGHSwitch PoE Quick Start Guide ™ Connecting Power 1. Connect the power connector of the Power Adapter to the Power port of the TOUGHSwitch. 2. Connect the Power Cord to the power port on the Power Adapter. Connect the other end of the Power Cord to a power outlet.
Hardware Installation Connecting Ethernet 1. Connect an Ethernet cable from the Ethernet port of your computer to the Management port of the TOUGHSwitch. 2. Connect Ethernet cables from the Ethernet ports of your devices to the numbered ports of the TOUGHSwitch. Note: PoE is disabled by default on all numbered ports and is not available on the Management port.
TOUGHSwitch PoE Quick Start Guide ™ Accessing the Configuration Interface Connect to the Configuration Interface by performing the following steps: 1. Ensure that your computer (or other host machine) is connected to the Management port on the TOUGHSwitch. Note: By default, you can configure the TOUGHSwitch via any port;...
Specifications Specifications TOUGHSwitch PoE Dimensions 197 x 87.5 x 27.3 mm Weight 250 g Power Input 24VDC, 2.5A Power Adapter (Included) Max. Power Consumption 60 W PoE Out Voltage Range 22-24VDC Max. PoE Wattage Per Data Port 11.5 W ESD Rating 24 kV Air / 24 kV Contact PoE Method Passive...
TOUGHSwitch PoE Quick Start Guide ™ Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm.
Buyer for breach of warranty and shall constitute fulfillment of all liabilities of UBIQUITI NETWORKS with respect to the quality and performance of the Products. UBIQUITI NETWORKS reserves the right to inspect all defective Products (which must be returned by Buyer to UBIQUITI NETWORKS factory freight prepaid).
TOUGHSwitch PoE Quick Start Guide ™ Returns In the unlikely event a defect occurs, please work through the dealer or distributor from which this product was purchased. Compliance Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Compliance Japan VCCI-A CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it. RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste.
Page 16
TOUGHSwitch PoE Quick Start Guide ™ Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
UBIQUITI NETWORKS device, megfelel a vonatkozó alapvetõ [Hungarian] követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak. Íslenska Hér me l sir UBIQUITI NETWORKS yfir ví a UBIQUITI NETWORKS device, er í samræmi vi grunnkröfur og a rar kröfur, sem ger ar eru í [Icelandic] tilskipun 1999/5/EC.
Page 18
Latviski Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist [Latvian] tajiem noteikumiem. Lietuviškai UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB [Lithuanian] Direktyvos nuostatas.