Setup - Life Fitness M051-00K61-A132 Operation Manual

Integrity series cross-trainer
Table of Contents

Advertisement

1.2
S
ETUP
Read the Operation Manual before setting up the Life Fitness Cross-Trainer.
W
P
HERE TO
LACE THE
Follow all safety instructions in Section 1.1 and move the Life Fitness Cross-Trainer to the location in which it will be used.
See Section 7 for the dimensions of the footprint. Allow 1 foot of clearance in front of the Life Fitness Cross-Trainer to
allow for movement of the pedal levers. It should be easy to mount the Life Fitness Cross-Trainer from the side.
H
S
OW TO
TABILIZE THE
After placing the Life Fitness Cross-Trainer in position, check the unit's stability by attempting to rock it. Any slight rocking
indicates that the unit must be leveled. Check the stabilizing feet to determine which foot does not rest fully on the floor.
Rotate the foot counter-clockwise to lower it. Recheck the stability and adjust again as needed until the Life Fitness
Cross-Trainer is stable and no longer rocks. Lock the adjustment into position by tightening the jam nut against the
stabilizer bar with an open end 9/16 inch wrench.
C
P
HECK FOR
OWER
The console is powered by a rechargeable 6-volt battery. Check the battery by pressing the START key. The console
should light up, and the MESSAGE CENTER should display a prompt to set up a workout. If this does not occur, mount
the Life Fitness Cross-Trainer and begin pedaling. The console should then light up, making it possible to program a work-
out. Pedal for 10 to 20 minutes at 1.5 mph (2.4 kph) or faster during a workout to charge the battery. Afterwards, the pedal
action during workouts keeps the battery charged. If the console still does not light, contact Life Fitness Customer Support
Services
F
E
ITNESS AND
NTERTAINMENT
Two interchangeable network ports allow the Life Fitness Cross-Trainer to be connected to a fitness entertainment system
and/or a network, such as FitLinxx
Networking: The built-in networking ports allow the unit to exchange workout information with a fitness network
database.
Fitness Entertainment: The network connection enables the console to power a third-party receiver for use with
a service such as the Cardio Theater
These ports are located on the back of the console and are enclosed by a removable cover. Any use of the ports for other
than their intended purpose could void the product warranty.
L
F
®
C
IFE
ITNESS
ROSS
L
F
C
IFE
ITNESS
ROSS
N
ETWORKING
TM
interactive fitness network.
®
entertainment system or the BroadcastVision
-T
RAINER
-T
RAINER
.
TM
entertainment system.
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Clsx

Table of Contents