Float Chamber - KYMCO SUPER8 50 Service Manual

5
. FUEL SYSTEM

FLOAT CHAMBER

DISASSEMBLY
Remove the three float chamber screws and
the float chamber.
Loosen the float pin screw.
Remove the float pin, float and float valve.
Remove the main jet, needle jet holder,
needle jet, slow jet and pilot screw.
• Be careful not to damage the fuel jets
and pilot screw.
• Before removing, turn the pilot screw
in and carefully count the number of
turns until it seats lightly and then
make a note of this.
• Do not force the pilot screw against its
seat to avoid seat damage.
Clean the removed fuel jets with detergent
oil and blow them open with compressed
air.
Blow compressed air through all passages
of the carburetor body.
Screws
Float Chamber
Float
Float Pin
Needle Jet Holder
Pilot Screw Needle Jet
SUPER8 50
Float Valve
Slow Jet
Main Jet
5-8