A.1. DATA OUT PoE Switch RJ-45 Port Pin Assignments (Port-1 to
Port-4)
A.2. 10/100Mbps, 10/100Base-TX
When connecting your 10/100Mbps Ethernet Switch to another switch, a bridge or a hub, a straight or crossover
cable is necessary. Each port of the Switch supports auto-MDI/MDI-X detection. That means you can directly
connect the Switch to any Ethernet devices without making a crossover cable. The following table and diagram
show the standard RJ-45 receptacle/ connector and their pin assignments:
RJ-45 Connector pin assignment
Contact
1
2
3
4, 5
6
7, 8
Appendix A. Networking Connection
PIN NO
RJ-45 SIGNAL ASSIGNMENT
Output Transmit Data +
1
Power +
Output Transmit Data –
2
Power +
Receive Data +
3
Power -
4
5
Receive Data –
6
Power -
7
8
Figure A-1
MDI
Media Dependant Interface
Tx + (transmit)
Tx - (transmit)
Rx + (receive)
Not used
Rx - (receive)
Not used
-79-
User's Manual of IAP-200x Series
-
-
-
-
MDI-X
Media Dependant Interface-Cross
Rx + (receive)
Rx - (receive)
Tx + (transmit)
Tx - (transmit)