Planet Networking & Communication WBS-202N Quick Manual

802.11n 300Mbps
Outdoor Wireless CPE
WBS-202N/WBS-502N
►

1. Package Contents

Thank you for choosing PLANET Outdoor Wireless CPE. Before installing,
please verify the contents inside the package box. The device mentioned
herein is the brief name of the "Outdoor Wireless CPE".
WBS-202N/WBS-502N
Ethernet Cable x 1
If there is any item missing or damaged, please contact the
seller immediately.
Note

3. Hardware Installation

Step 1: Push the latch on the bottom of the Outdoor Wireless CPE to
remove the sliding cover.
Step 2: Plug the RJ45 Ethernet cable into the PoE Port of the Outdoor
Wireless CPE. Then, slide back the cover to finish the
installation.
Step 3: Place the mounting strap through the slot on the back of the
Outdoor Wireless CPE and then around the pole. Tighten the
mounting strap to secure the Outdoor Wireless CPE.
To PoE Switch
Quick Guide
Mounting Strap x 1
– 1 –
– 3 –
IMPORTANT SAFETY PRECAUTIONS:
1) LIVES MAY BE AT RISK!
electrical wires around. Carefully read the section
"OUTDOOR INSTALLATION WARNING" in the manual
before installation.
2) Users MUST complete grounding wired with the device;
otherwise, a sudden lightning could cause fatal damage to
the device. EMD
COVERED UNDER WARRANTY.
2. Physical Introduction
Hardware Description
LAN WDS Switch
PoE
4. Wired Network Configuration
(Windows 7 and Windows 10)
A computer with wired Ethernet connection is required for the first-time
configuration of the Wireless AP.
1. Click the "Start" button located at the lower-left corner of your
computer.
2. Select "Control Panel-> Network and Sharing Center".
3. Click "Change adapter settings".
4. Double-click "Local Area Connection".
5. Select "Internet Protocol Version 4 (TCP/IPv4)" and click
"Properties".
6. Select "Use the following IP address" to configure the IP address
to "192.168.1.x" ("x" can be any number from 2 to 254, except
253) and then click the "OK" button to save the configuration.
Please be aware of the
(Lightning) DAMAGE IS
DC Power
Reset/Pair
– 2 –
– 4 –
NOT