Planet Networking & Communication WNAP-C3220 Quick Installation Manual

Quick Installation Guide
WNAP-C3220
802.11n Ceiling Mount Wireless
Range Extender / Access Point

1. Package Contents

Thank you for choosing PLANET WNAP-C3220. Before installing
the AP, please verify the contents inside the package box.
Wireless AP
Ethernet Cable
If there is any item missing or damaged, please
contact the seller immediately.
Note

3. Hardware Installation

Step 1: Attach the bracket to the wall or ceiling, and mark
each point in the bracket for the screws. Remove
the bracket to drill the points and insert the plastic
wall-mounts. Use screws to lock the bracket by a
screw driver.
Step 2: Plug the RJ-45 Ethernet cable into the WNAP-C3220.
Quick Guide
Power Adapter Mounting Kit
– 1 –
– 3 –
2. Physical Introduction
Front Panel Description
CD-ROM
Rear Panel Description
x 4 x 4
1 x 10/100/1000Mbps PoE LAN Port
Step 3: Plug the power adapter into the WNAP-C3220.
Step 4: Attach the WNAP-C3220
Note
Reset Button
Power Connector 12V DC Input
– 2 –
If WNAP-C3220 is connected to an 802.3af PoE
switch in STEP 2, you don't have to plug the power
adapter.
to the mounting
bracket.
1. ONLY use the power adapter supplied with
WNAP-C3220. Otherwise, the product may be
damaged.
2. For the power supply of WNAP-C3220, you could
use either IEEE 802.3af PSE device or 12V DC
adapter. Please do not use 12V adapter and PSE
device at the same time. It may damage the
WNAP-C3220 itself.
– 4 –
Power LED
Step 5: Installation is
successfully
completed.