Planet Networking & Communication WDAP-C7400 Quick Installation Manual

Quick Installation Guide
WDAP-C7400
900Mbps Dual Band Ceiling Mount
Wireless Access Point

1. Package Contents

Thank you for choosing PLANET WDAP-C7400. Before installing
the AP, please verify the contents inside the package box.
The WDAP-C7400 should contain the following items in the
package:
Wireless AP
Quick Guide
If there is any item missing or damaged, please
contact the seller immediately.
Note

3. Hardware Installation

STEP 1: Plug the Ethernet cable into the PoE port.
STEP 2: Plug the other end of the Ethernet cable into the PoE
switch.
Power Requirement: 802.3at 30W power source is required.
Ceiling Plate CD-ROM
Mounting Kit
x 5 x 5
– 1 –
802.3at PoE Switch
– 3 –
2. Physical Introduction
Hardware Description
Wi-Fi (2.4G) LED
Power LED
RESET
Reset: Press and hold the reset button for more than 7
seconds to reset to the factory default setting.
STEP 3: Mounting:
(1) Attach the Ceiling Plate to the ceiling.
(2) Mark each point in the Ceiling Plate for the
screws.
(3) Remove the Ceiling Plate to drill the points and
insert the plastic wall-mounts.
(4) Use screws to lock the Ceiling Plate by a screw
driver.
STEP 4: Attach the WDAP-C7400 to the Ceiling Plate.
Wi-Fi (5G) LED
PoE LAN
– 2 –
screw
– 4 –