12
SERVICE WORK ON THE CHASSIS
12.50
Removing the engine guard
12.51
Installing the engine guard
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01538-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
4
C00608-10
–
Inject the liquid into the system until it escapes from openings
der without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below top edge of container
–
Position the cover with the membrane. Mount and tighten the screws.
B01540-10
–
Turn quick release
guard.
C00611-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Turn quick release
C00612-10
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 108)
.
counterclockwise until it disengages. Remove the engine
1
clockwise all the way.
1
and mount bleeding
5
of the master cylin-
6
4 mm (0.16 in)
64