17
TUNING THE ENGINE
17.1
Checking the play in the throttle cable
17.2
Adjusting the play in the throttle cable
–
Check the throttle grip for smooth operation.
–
Move the handlebar to the straight-ahead position. Move the throttle grip back and
forth slightly to ascertain play
Play in throttle cable
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
Danger
400192-11
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
–
Check the routing of the throttle cable. (
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeves
–
Loosen nut
–
Loosen nut
at the throttle grip.
Guideline
Play in throttle cable
–
Tighten nut
–
Press and hold the throttle grip in the closed setting. Turn adjusting screw
until there is no play in throttle cable
–
Tighten nut
–
Push sleeves
C00606-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the play in the throttle cable. (
in the throttle cable.
A
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
x
p. 49)
(
p. 56)
x
.
1
. Turn adjusting screw
2
3
. Turn adjusting screw
4
5
.
4
6
.
2
on. Check the throttle grip for smooth operation.
1
(
p. 57)
x
p. 49)
3... 5 mm (0.12... 0.2 in)
(
p. 89)
x
x
(
p. 89)
p. 62)
in as far as possible.
so that there is play
in the throttle cable
A
3... 5 mm (0.12... 0.2 in)
.
p. 89)
89
out
3