Husqvarna FE 450 EU Owner's Manual page 42

11 TUNING THE CHASSIS
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten screws
101860-10
Guideline
Screw, handlebar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
. Take off the handlebar clamps. Take off the handlebar and lay it
1
. Take off the handlebar supports.
2
M10
M8
Loctite 243™
40 Nm ®
(29.5 lbf ft)
evenly.
1
20 Nm (14.8 lbf ft)
40
.
2