12
SERVICE WORK ON THE CHASSIS
12.14
Adjusting the play of the steering head bearing
12.15
Lubricating the steering head bearing
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
»
If there is noticeable play present:
–
Adjust the play of the steering head bearing.
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No rest-
400738-11
ing locations should be noticeable.
»
If click positions are noticeable:
–
Adjust the play of the steering head bearing.
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
C00570-10
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
x
. Remove screw
.
1
2
.
3
.
1
.
2
M8
x
(
p. 44)
x
(
p. 45)
x
p. 41)
(
p. 47)
x
(
p. 47)
x
p. 41)
p. 41)
M20x1.5
12 Nm (8.9 lbf ft)
M8
17 Nm (12.5 lbf ft)
17 Nm
Loctite
(12.5 lbf ft)
p. 46)
p. 41)
47
®
243™