Lldp Port-Number-Type - Allied Telesis AT-IX5-28GPX Manual

LLDP C
OMMANDS
- -
LLDP PORT NUMBER TYPE

lldp port-number-type

Overview This command sets the type of port identifier used to enumerate, that is to count,
the LLDP MIB local port entries. The LLDP MIB (IEEE Standard 802.1AB-2005,
Section 12, LLDP MIB Definitions.) requires the port number value to count LLDP
local port entries.
This command also enables you to optionally set an interface index to enumerate
the LLDP MIB local port entries, if required by your management system.
The no variant of this command resets the type of port identifier back to the
default setting (number).
Syntax
lldp port-number-type [number|ifindex]
no lldp port-number-type
Default The default port identifier type is number. The no variant of this command sets the
port identifier type to the default.
Mode Global Configuration
Examples To set the type of port identifier used to enumerate LLDP MIB local port entries to
port numbers, use the commands:
awplus#
awplus(config)#
To set the type of port identifier used to enumerate LLDP MIB local port entries to
interface indexes, use the commands:
awplus#
awplus(config)#
To reset the type of port identifier used to enumerate LLDP MIB local port entries
the default (port numbers), use the commands:
awplus#
awplus(config)#
Related show lldp
Commands
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Set the type of port identifier to a port number to enumerate the
number
LLDP MIB local port entries.
Set the type of port identifier to an interface index to enumerate the
ifindex
LLDP MIB local port entries.
configure terminal
lldp port-number-type number
configure terminal
lldp port-number-type ifindex
configure terminal
no lldp port-number-type
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
1705