Your Ceiling Fan How To Hang - Emerson HIGHPOINTE CF205BS01 Owner's Manual

15. Place the ceiling cover over the down-
rod. Then reinstall the hanger ball
(Figure 13) on the downrod as follows.
Route the three 80" motor leads
through the hanger ball and slide the
hanger ball over the downrod. Position
the pin through the two holes in the
downrod and align the hanger ball so
the pin is captured in the groove in the
top of the hanger ball. Pull the hanger
ball up tight against the pin and
securely tighten the setscrew in the
hanger ball. A loose setscrew could
create fan wobble.
PIN
DOWNROD
CEILING
COVER
Figure 13
16. The fan comes with blue, black and
white leads that are 80" long. Before
installing the fan, measure up approxi-
mately 6 to 9-inches above top of
hanger ball/downrod assembly. Cut off
excess leads and strip back insulation
1/2" from end of leads.
17. You have now completed the initial
assembly of your new ceiling fan. You
can now proceed with hanging and
wiring your fan.
The fan must be hung with at least 7'
of clearance from floor to blades
(Figure 14).
AT LEAST
HANGERBALL
Figure 14
The outlet box and joist must be
securely mounted and capable of
supporting at least 50 lbs. Use only a
SETSCREW
U.L. outlet box listed as "Acceptable
for Fan Support".
To reduce the risk of fire, electric
shock, or personal injury, mount fan
to outlet box marked "Acceptable for
Fan Support", and use screws sup-
plied with outlet box. Most outlet
boxes commonly used for support of
light fixtures are not acceptable for
fan support and may need to be
replaced. Consult a qualified electri-
cian if in doubt.
1. Securely attach the hanger bracket to
8
How to Hang
Your Ceiling Fan
WARNING
!
CEILING
7'
FLOOR
WARNING
!
WARNING
!
the outlet box using the two screws
supplied with the outlet box (Figure 15).
U.L. Model No.: CF205