Emerson HIGHPOINTE CF205BS01 Owner's Manual page 12

How to Disassemble Your Light Kit for
WARNING
!
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned
off at the main fuse box before
wiring. All wiring must be in accor-
dance with National and Local codes
and the ceiling fan must be properly
grounded as a precaution against
possible electrical shock.
CAUTION: To reduce the risk of electri-
cal shock, disconnect the electrical
supply circuit before installing the fan,
light kit or receiver.
1. Detach the light kit plate from the fan
motor/housing assembly by removing
one screw and loosening the two other
screws (located in the keyholes).
Rotate the light kit plate counter-
clockwise to disengaging the screws in
the two key hole slots (Figure 21).
FAN MOTOR/
HOUSING
ASSEMBLY
BLUE WIRE
BLACK WIRE
LIGHT KIT PLATE
Figure 21
2. Disconnect the black wire of the light kit
plate from the black wire of the fan
motor/housing assembly. Disconnect the
white wire of the light kit plate from the
white wire of the fan motor/housing
assembly (Figure 22).
Cover Plate Assembly Only
WHITE WIRES
CUT LIGHT SOCKET WIRES
LIGHT KIT PLATE
Figure 22
3. Cut light socket wires using wire cut-
ters. Unscrew the screws that is secur-
ing the socket plates to the light kit
plate. Pull socket wiring though light kit
plate holes to completely disengage
the light sockets from light kit plate
(Figure 23).
REASSEMBLE
LIGHT KIT
PLATE
REMOVE SOCKET/
SOCKET PLATE (2)
Figure 23
12
CUT LIGHT
SOCKET WIRES
REASSEMBLE
MOTOR SCREW (3)
REMOVE SOCKET
PLATE SCREWS
(2 per plate)
U.L. Model No.: CF205