Emerson HIGHPOINTE CF205BS01 Owner's Manual page 7

11. Make sure the grommets are properly
installed in the rod support assembly.
Then position the three screws in the
rod support toward the top, and slide
the rod support over the downrod
(Figure 10).
ROD SUPPORT
ASSEMBLY
MOTOR
HOUSING
Figure 10
12. Using the decorative rod screws (sup-
plied), attach the three decorative rod
assemblies to the motor housing
(Figure 11). The decorative rods must
be oriented so that they lean in
towards the downrod. Do not tighten
the rod screws at this time.
DECORATIVE ROD
ASSEMBLY
DECORATIVE
ROD SCREW
Figure 11
13. Slide the rod support assembly up
GROMMET
14. Rotate the rod support assembly until
SCREWS (3)
(Toward Top)
COUPLING
COVER
DOWNROD
DECORATIVE
ROD SCREW
DECORATIVE
ROD
ASSEMBLY
Figure 12
It is critical that the pin in the hanger
ball is properly installed and the
setscrew securely tightened. Failure
to verify that the pin and setscrew
are properly installed could result in
the fan falling.
7
the downrod until the threaded holes in
the rod support align with the
holes in the decorative rod assemblies
(Figure 12). Secure the decorative
rods to the rod support using three
decorative rod screws; do not tighten
the rod screws at this time.
the decorative rod assemblies are
aligned vertically with the downrod
(Figure 12). Hold the rod support in
this position while tightening all six
decorative rod screws securely.
WARNING
!
U.L. Model No.: CF205
ROD
SUPPORT
ASSEMBLY