Brake Fluid Level Check - VESPA GTV 125 Service Station Manual

Vespa GTV 125
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO COMPLY WITH THIS NORM WILL ENDANGER THE PROPER WORKING AND
EFFICIENCY OF THE BRAKING SYSTEM
Specific tooling
020329Y MityVac vacuum-operated pump
Locking torques (N*m)
System bleed calliper fitting: 20 ÷ 25 Nm

Brake fluid level check

- Position the vehicle on a flat surface and on the
centre stand
- Remove the brake pump cover as indicated in the
photo
- Use the appropriate spyglass on the pump to
check the level of the brake fluid, as shown in the
photograph
- If the level is below the minimum, fill using the two
screws shown in the figure
- Remove the gasket and fill with DOT 4 until the
spyglass is completely covered
CAUTION
MAKE SURE THE BRAKE FLUID DOES NOT
GET INTO YOUR EYES OR ON YOUR SKIN OR
CLOTHES. IF THIS HAPPENS ACCIDENTALLY,
WASH WITH WATER.
CAUTION
THE BRAKING CIRCUIT FLUID IS HIGHLY
CORROSIVE. THEREFORE, WHEN TOPPING
IT UP, AVOID LETTING IT COME INTO CON-
TACT WITH THE PAINTED PARTS OF THE VE-
Braking system
BRAK SYS - 13