Switch System On/Off; Battery & Signal - Bosch DICENTIS Configuration Manual

24 en | Web interface application
5.6

Switch system on/off

Preconditions:
–
Use the Switch system on/off button to set the system in the "power on" or "power off"
mode:
–
–
–
–
5.7 Battery & Signal
Preconditions:
–
Click the Battery & Signal button to open the Battery and Signal overview page.
The following information is shown for each seat that is currently connected to the Wireless
Access Point:
Note: If a seat is disconnected, the disconnect symbol is displayed to the left of the seat row,
and the data in the seat row is not displayed.
–
–
–
–
–
–
2015.03 | V1.0 |
The logged on user must have the access right: Prepare system.
Click the Switch system on button to set the system in the "power on" mode.
Press the microphone request button of a Wireless Device to switch it on.
Note: The Wireless Devices have to be switched on individually.
Click the Switch system off button to set the system in the "power off" mode. This will
switch off all Wireless Devices.
Note: If you try to switch on a Wireless Device, by pressing the microphone request
button when the system is in the "power off" mode, the device will momentarily switch
on and then switch off.
The logged on user must have the access right: Configure or Prepare system.
Seat: The seat name.
Battery: Indicates the remaining power supply capacity, in hours, of the Wireless Device
Battery Pack.
Note: After replacing a battery or powering up a Wireless Device, the number of battery
hours displayed might be higher that the actual life of the battery. This value will stabilize
after a short while.
Charges: Shows the number of times the Battery Pack battery is charged.
Signal: Indicates the WiFi signal strength, in dBm.
Test: This column shows the result of the range test.
– Press the button to Start the range test. The system DCNM-WAP starts to measure if
all Wireless Devices are in range of several frequencies. This guarantees that the
Wireless Devices will continue to work if the DCNM-WAP decides to switch to
another WiFi channel in case of interference.
Serial number: The serial number of the Battery Pack.
Configuration manual
DICENTIS
Bosch Security Systems B.V.