Seats - Bosch DICENTIS Configuration Manual

20 en | Web interface application
–
5.4.7

Seats

Click the Seats button to open the Seats settings page.
Here the Wireless Devices can be assigned to seats:
–
–
–
–
–
2015.03 | V1.0 |
– Hostname: Enter the network name of the DCNM-WAP. The default name is
dcnm‑wap.
– Change network settings button: Click this button to open the change settings
screen. Change the settings, if required, and click either the Cancel or Save button.
General settings:
– DCNM‑WDE GUI language: Select the GUI language for the DCNM-WDE Wireless
Devices touch screen.
– Show custom logo on DCNM‑WDE: When selected, the custom logo will be visible
on the Wireless Devices (DCNM-WDE) touch screen.
– Factory default button: Click the button to reset the Wireless Access Point to factory
default settings and values. Important: Make sure all Wireless Devices are switched
on and are in range before you activate the factory default because all Wireless
Devices will be de-initialized. After a factory default, all settings are returned to their
default value, and all Wireless Devices need to be subscribed.
Seats overview:
– Select: The header of this column shows the number of known seats and the number
of connected seats. If a seat is disconnected, the disconnect symbol is displayed to
the left of the seat row.
– Seat name: Change the seat name.
– Prio: When selected, the participant is able to use the Wireless Device priority
(chairperson) button.
– Dual: When selected, the Wireless Device is configured for dual-use.
Note: A device cannot be prio and dual simultaneously, so when Prio is selected, the
dual checkbox is disabled.
– ID: When selected, the identification feature is enabled. Participants can use an NFC
tag to identify themselves at the Wireless Device Extended.
– Voting: When selected, the voting feature is enabled. Participants can cast their vote
at the Wireless Device Extended.
– Serial nr: The serial number of the connected Wireless Device.
– Camera: The camera name connected to the seat. Only available when the camera
control license is installed.
– Pre‑position: Camera preposition setting number assigned to the seat. Only available
when the camera control license is installed.
Selection mode: When selected, a Wireless Device can be located by clicking the Select
symbol to the left of the seat row. The red microphone LED on the selected Wireless
Device will illuminate to indicate its position in the conference room.
Subscription mode: When selected, a Wireless Device not associated with a DCNM-WAP,
can be associated with this DCNM-WAP by pressing the request button on the wireless
device. A new seat will be assigned to this device and added to the seats overview. Refer
to Wireless Device initialization, page 9.
De‑init button: When clicked, it erases the subscription of all Wireless Device. All LEDs on
the Wireless Device are on when the Wireless Device does not have a subscription.
Remove disconnected seats button: Removes all seats which are currently not connected
to the system.
Configuration manual
DICENTIS
Bosch Security Systems B.V.