Equalizer; Cameras - Bosch DICENTIS Configuration Manual

18 en | Web interface application
5.4.3

Equalizer

Click the Equalizer button to open the Equalizer settings page:
The Equalizer page is used to set the equalizer settings of the audio line input and output of
the Wireless Access Point and Wireless Devices loudspeaker.
Equalizer filters
–
–
–
Equalizer settings
Proceed as follows to configure a filter:
1.
2.
3.
4.
5.4.4

Cameras

Click the Cameras button to open the Camera settings page:
–
–
–
–
Notice!
Ensure that the Bosch Onvif Camera has firmware 5.80 or higher.
2015.03 | V1.0 |
– When Send test tone to loudspeakers is selected, generates the selected test tone
to the connected Wireless Devices headphone.
– When Send test tone to loudspeakers is selected, generates the selected test tone
to the audio line output of the Wireless Access Point.
Filter 1 type: Shelving filter - A shelving filter for low frequencies with a fixed quality
factor.
Filter 2, 3, 4 type: Full parametric section - Three full parametric filters with adjustable
quality factors, gains and frequencies.
Filter 4 type: Shelving filter - A shelving filter for high frequencies with a fixed quality
factor.
Enter the frequency of the filter. Possible values from 50 Hz up to 22 kHz.
Enter the gain of the filter. Possible values from -12 dB to +12 dB with steps of 0.1.
Enter the quality (Q) factor of the filter. Possible values from 0.4 to 14 with steps of 0.1.
Enable or bypass the filter by clicking the checkmark. All changes are immediately
applied.
Overview Camera: Defines the camera used as the overview camera.
Preposition: Defines the preposition camera used for the overview. Only available when a
PTZ/Dome camera has been selected as an overview camera (if a fixed camera or None is
selected, this field is not visible).
SDI Switcher: Enter the IP address of the HD‑SDI video switcher used. Do not use leading
zeros. If leading zeros are entered, the DCNM-WAP will not be able to control the
switcher.
– Example:
Correct IP address: 192.168.10.111
Incorrect IP address: 192.168.010.111
Overview list: Here all connected cameras are listed. The overview list shows: the Camera
name, Serial number, Software version, camera Type and to which video switcher Input
the camera is connected to.
– The camera Serial number is used as a link to the camera configuration web pages.
Note: Only possible if your PC/laptop or tablet device is connected via the wired
Ethernet connection of the DCNM-WAP.
– A trash can is displayed next to the Camera name for removing a selected camera.
Note: Only a disconnected camera can be removed.
Configuration manual
DICENTIS
Bosch Security Systems B.V.