Electric Choke; Throttle Cable Free-Play - Arctic Cat 2014 400 TRV Service Manual

Electric Choke

REMOVING
1. Disconnect the electric choke connector from the
wiring harness; then remove the screw securing the
choke body to the carburetor.
2. Carefully remove the choke assembly from the car-
buretor taking care not to force the plunger from the
carburetor body.
INSPECTING/TESTING
1. Inspect the plunger (A) for scoring or scratches, the
needle (B) for damage to the tip, the spring (C) for
breakage, and the O-ring (D) for breaks.
2. With the choke at room temperature (approximately
70° F), measure plunger extension. Measurement (A)
should be 18.6-19.1 mm.
3. Connect Electric Choke Test Harness to the choke
connector and a suitable 12 DC volt power supply
for 2-3 minutes. Disconnect the power and measure
plunger extension. Measurement (B) should be
22.1-23.4 mm.
82
4. If the choke is damaged or the measurements are not
within specifications, the choke must be replaced.
INSTALLING
1. Lightly lubricate the O-ring on the choke body; then
carefully insert the choke assembly into the carbure-
tor being careful not to damage the plunger.
2. Secure the choke with the screw and tighten
securely; then connect the choke connector to the
wiring harness.

Throttle Cable Free-Play

To adjust the throttle cable free-play, follow this proce-
dure.
KC328A
1. Slide the rubber boot away; then loosen the jam nut
from the throttle cable adjuster.
2. Turn the adjuster until the throttle cable has proper
KC328B
free-play of 3-6 mm (1/8-1/4 in.) at the lever.
KC328C
AL611D