Important Safety Instructions - Liebert PowerSure PS250-60S User Manual

IMPORTANT SAFETY INSTRUCTIONS

WARNING: Do not attempt to service this product yourself except to
replace the battery. Opening or removing the cover may expose you to
dangerous voltages, even when the AC cord is disconnected from the
electrical outlet. Refer all servicing to qualified service personnel.
1. SAVE THESE INSTRUCTIONS.
INSTRUCTIONS AND WARNINGS ON THE UNIT AND IN THIS MANUAL.
CONSERVER CES INSTRUCTIONS.
IMPORTANTES CONCERNANT LA SÉCURITÉ.
2. Liebert Corporation neither recommends nor knowingly sells this product for
use with life support or other U.S. FDA designated "critical" devices.
3. CAUTION: A BATTERY PRESENTS A RISK OF ELECTRICAL SHOCK OR
BURN FROM HIGH SHORT CIRCUIT CURRENT. OBSERVE PROPER
PRECAUTIONS.
ATTENTION: UNE BATTERIE PEUT PRÉSENTER UN RiSQUE DE CHOC ÉLECTRIQUEÉ DE
BRULURE PAR TRANSFERT D'ÉNERGIE. SUIVRE LES PRÉCATIONS QUI S'IMPOSENT.
4. WARNING: To reduce risk of fire or electric shock, install in a temperature
and humidity controlled area free from conductive contaminants.
AVERTISSEMENT: POUR RÉDUIRE LE RISQUE D'INCENDLE OU DE CHOC ÉLECTRIQUEÉ,
INSTALLE DANS
CONTROLÉE EXAMPT DE POLLUANTS CONDUCTEURS.
5. Operate the UPS indoors only. Protect it from moisture and install it in a
clean environment, free from flammable liquids, gases, or corrosive
substances.
6. WARNING: Do not modify cable. Consult dealer if connector does not
match equipment. UPS must be grounded at all times while in use. Turn
UPS OFF before unplugging, or the safety ground from UPS to equipment
will be removed
7. CAUTION: Output receptacles on the UPS are electrically live if the UPS is
ON, even if the UPS is not plugged in. The on/off switch on the UPS does
not electrically isolate the internal parts. To isolate the UPS, unplug it.
8. CAUTION: Ground leakage current must not exceed 2.75 milli-amperes.
Most data processing equipment meets this requirement if you use no more
than 4 pieces of equipment. Note: These instructions may be modified by
local wiring regulations.
9. Unplug the UPS and turn the power switch OFF before cleaning. Use only
water dampened cloth, never liquid or aerosol cleaners.
10. Do not plug appliances, such as hair dryers or heaters into UPS receptacles.
11. Operate the UPS only from a grounded outlet (2 wire plus ground) 120 VAC,
60 Hz.
12. The UPS is equipped with a grounded NEMA 5-15 input power plug. Do not
defeat the safety purpose of this plug. If unable to fully insert the plug into
the outlet, contact an electrician.
13. Route power supply cords so they are not walked on or pinched.
14. Never block or insert any object into ventilation holes or other openings.
Maintain a minimum clearance of four inches all around the UPS for proper
airflow and cooling.
15. Always turn OFF the UPS and unplug it before opening battery door. To
replace batteries, refer to battery replacement procedure.
UN SECTEUR AVEC TEMPÉRATURE CONTROLÉ ET HUMIDITÉ
ADHERE TO ALL OPERATING
CETTE NOTICE CONTIENT DES INSTRUCTIONS
2
If you feel