Important Safety Instructions - Liebert PowerSure Personal XT 450 User Manual

IMPORTANT SAFETY INSTRUCTIONS

This manual contains important safety instructions that should be followed during
the installation and maintenance of the UPS and its batteries. Please read this
manual thoroughly before attempting to install or operate this UPS.
This equipment can be installed and operated by individuals without previous
training.
1. PowerSure Personal XT models are available for 230VAC supply voltages and
loads. Please verify that this model matches your AC mains/ load voltage
requirements.
2. This equipment is designed for Commercial/Industrial use only. Liebert
Corporation neither recommends nor knowingly sells this product for use in
critical life support applications.
3. The PowerSure Personal XT 230VAC models are not supplied with an input
power lead for connection to the mains supply. Use the input mains power
lead from your data processing equipment to connect the UPS to the mains
supply. The UPS is supplied with two output power leads with moulded
connectors to connect from the UPS output to your equipment. Additional
input/output leads can be obtained from your dealer.
Also provided is a Liebert special interconnection cable for connection to
DB9 connector on the rear of the UPS for use with Liebert's SiteNet
MultiLink® software (see user manual for details) DO NOT USE FOR
OTHER APPLICATIONS. Store in safe place if not required at this time.
4. This UPS must be earthed at all times during operation. Connect only to a
mains supply socket outlet with an earth connection. A means of disconnection of
the mains supply should be within 2 metres of the UPS.
5. WARNING: Output receptacles on the UPS are electrically live if the UPS is
switched ON, even if the UPS is not plugged in to a mains supply. The
On/Off button on the UPS does not electrically isolate the internal parts. To
.
isolate the UPS, switch OFF the UPS first, then unplug it from the mains.
To reduce the risk of electric shock, do not remove the cover, as it has no
user-serviceable parts inside. Some components are live, even when AC
.
power is disconnected. For service, contact a qualified technician.
.
To reduce the risk of fire, use the proper rating when replacing the fuse.
To prevent the risk of fire or electric shock, install the UPS in a temperature
and humidity controlled room, free of conductive contaminants.
6. Your total load earth leakage current must not exceed 3.5 milli-amperes.
Most data processing equipment meets this requirement if you use no more
than 2 pieces of equipment. For further advice contact your dealer.
7. The UPS relies on your building wiring overcurrent protection, which must be
rated between 10-20 amperes.
8. When using the communication features on the UPS, ensure the cabling
connected to the DB9 communication port or the network connection are
kept separated by 25mm from the power leads to the UPS input and output.
SAVE THESE INSTRUCTIONS
2