Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important safety instructions that should be followed during the
installation and maintenance of the UPS and its batteries.
thoroughly before attempting to install or operate this UPS.
This equipment can be installed and operated by individuals without previous training.
1.
PowerSure Personal models are available for 115VAC and 230VAC supply voltages and
loads. Please verify that this model matches your AC mains/ load voltage requirements.
2.
This equipment is designed for Commercial/Industrial use only. Liebert Corporation
neither recommends nor knowingly sells this product for use in critical life support
applications.
3.
The PowerSure Personal 230VAC models are not supplied with an input power lead for
connection to the mains supply. Use the input mains power lead from your data
processing equipment to connect the UPS to the mains supply. The UPS is supplied with
two output power leads with moulded connectors to connect from the UPS output to your
equipment. Additional input/output leads can be obtained from your dealer.
Also provided is a Liebert special interconnection cable for connection to DB9 connector
on the rear of the UPS for use with Liebert's SiteNet MultiLink® software (see user
manual for details) DO NOT USE FOR OTHER APPLICATIONS. Store in safe place if
not required at this time.
4.
This UPS must be earthed at all times during operation. Connect only to a mains supply
socket outlet with an earth connection. A means of disconnection of the mains supply
should be within 2 metres of the UPS.
5.
WARNING: Output receptacles on the UPS are electrically live if the UPS is switched
ON, even if the UPS is not plugged in to a mains supply. The On/Off button on the UPS
does not electrically isolate the internal parts. To isolate the UPS, switch OFF the UPS
first, then unplug it from the mains.
S
To reduce the risk of electric shock, do not remove the cover, as it has no user-
serviceable parts inside.
Some components are live, even when AC power is
disconnected. For service, contact a qualified technician.
S
To reduce the risk of fire, use the proper rating when replacing the fuse.
S
To prevent the risk of fire or electric shock, install the UPS in a temperature and humidity
controlled room, free of conductive contaminants.
6.
Your total load earth leakage current must not exceed 2.75 milli-amperes. Most data
processing equipment meets this requirement if you use no more than 2 pieces of
equipment. For further advice contact your dealer.
7.
The UPS relies on your building wiring overcurrent protection, which must be rated
between 10-20 amperes.
8.
When using the communication features on the UPS, ensure the cabling connected to
the DB9 communication port or the network connection are kept separated by 25mm
from the power leads to the UPS input and output.
Please read this manual
2
Advertisement
Table of Contents
