Event Notification - Promise Technology VTRAK 15100 User Manual

VTrak 15100 User Manual

Event Notification

When you select Event Notification, WebPAM PRO sends popup and/or email
messages regarding its status. The messages you see depend on your
notification selection (see Chapter 4) and what is currently happening in the
VTrak.
The chart below gives the suggested action when the corresponding message is
displayed.
Event
Controller Notification
Controller Unknown Error Unspecified problem with the Controller.*
Data Parity Error
Command Parity Error
Bus Reset
Unrecoverable Error
Abort Task
Clear ACA
LUN Reset
Initiator Error
Illegal Secondary Identify A target received a second Identify message with a
Message Parity Error
Bus Reboot
Connection Notification
Connection Made
Connection Lost
Disk Notification
Disk Down
SCSI data parity error.*
SCSI command parity error.*
The Initiator sent a command to reset the SCSI bus,
to correct a problem.*
Restart the Promise Product to clear the problem.*
A normal event. Result of user action.
Cleared an auto contingent alliance condition.*
A normal event. Result of user action.
SCSI error on the HBA card.*
different LUN.*
SCSI message parity error.*
The VTrak rebooted itself.*
* An occasional incident of one of these messages
does not necessarily indicate a problem. However,
if any of these messages appears repeatedly,
contact Technical Support.
Normal result of logging in.
Normal result of logging out. Also a result of poor
SCSI cable or network connection.
Identify the disk drive involved. Power down the
system, remove and test the drive. Replace the drive
as needed.
160
Action