Replace Raid Controller - Promise Technology VTRAK 15100 User Manual

Hide thumbs Also See for VTRAK 15100:
Table of Contents

Advertisement

VTrak 15100 User Manual

Replace RAID Controller

The RAID Controller monitors and manages the logical drives. When this
controller is replaced, all of your logical drive data and configurations remain
intact because this logical drive information is stored on the disk drives.
To remove and replace the RAID Controller, do the following:
1.
Power down the VTrak.
2.
Remove the network, SCSI and null modem cables.
3.
Grasp the handle and pull it toward you (above, left).
4.
Grasp the Controller and pull it out of the enclosure (above, center).
5.
Gently slide the new Controller into the enclosure.
6.
Press on the front to seat the Controller (above, right). The handle will swing
in as the Controller is properly seated.
7.
Attach the network, SCSI and null modem cables.
8.
Power up the VTrak.
This completes the RAID Controller replacement procedure.
Do not replace the RAID Controller based on LED colors alone.
Only replace the RAID Controller when directed to do so by
Promise Technical Support. See Chapter 9.
Important
140

Advertisement

Table of Contents
loading

Table of Contents