Locking Battery Charger Settings; Fault Codes - Projecta IC700 User Manual

CALCIUM (BULK AND ABSORPTION 14.7 VOLTS, EQUALISATION AND
RECONDITION UP TO 16 VOLTS)
This charge mode is best suited for Calcium batteries that have been deeply discharged
and require an equalization charge to restore a full electrolyte reading. If the battery
requires a simple 'top-up', the WET charge mode can be used.
LOCKING THE BATTERY CHARGER SETTINGS
Locking the battery charger settings will disable the CHARGE RATE & MODE keys from
use. This function is ideal for hire vehicles etc as it prevents the chargers settings from
being altered if the keys are touched.
To lock; press and hold the 'CHARGE RATE' and 'MODE' keys for 3 seconds until all the
LEDs illuminate. This indicates the keys are now locked.
To unlock; press and hold and 'CHARGE RATE' and 'MODE' keys for 3 seconds until all
the LEDs illuminate. This indicates the keys are now unlocked.

FAULT CODES

There are three error codes that may be displayed. These will be displayed in the
following way:
Power Charging
(Red LED) (Blue LED)
___ ___ ___
(Slow Flash)
– – – – – – –
(Fast Flash)
___ ___ ___
(Slow Flash)
Full
(Green LED)
OFF OFF
OFF OFF
OFF ON
Fault Remedy
Short circuit Check clips are not
or reverse touching each other
connection OR
of the clips Check the clips are
correctly connected
to the battery
Bulk charging Battery may
has timed out be faulty
and stopped
after 22 hours
The charger Battery may be
has entered faulty and may
recondition mode need replacing
3 times and has OR
timed out There is a load
on the battery
causing the battery
to fail Analysis
13