Execute Depends On Speed(Default Mode); Resume The Oil And Power System; Tracker's Hardware Resetting; Sleep Mode - Coban gps104 TK104 User Manual

tracker will stop the car immediately after "stop" command.
Send command "stop+password" to tracker, tracker will execute it and reply "Stop
engine Succeed". And it will remain immobile state until next command to resume.

19.2. Execute depends on speed(Default mode)

Send command "noquickstop+password" to tracker, It will reply "noquickstop OK",
Then the tracker won't stop the car immediately after "stop" command during the
speed above 20KM/H, instead, it will reply "it will be executed after speed less than
20KM/H", and stop the car when the speed is less than 20KM/H.

20. Resume the Oil and Power System

Send "resume+password" to tracker, it will reply "Resume engine succeed", that means
vehicle has resume the oil supply.
21.

Tracker's Hardware Resetting

Send SMS "reset+password" to tracker device to reset the GSM module and GPS module
of the tracker device, it will reply "reset ok".

22. Sleep Mode

22.1. Sleep by time

Send "sleep+password+space+time", tracker will reply "sleep time ok" if none of the
alarms/alerts has been set and no operations in 5 minutes, tracker will fall asleep, GPS
module shut off, and LED will be off too. Calling or SMS can awake the tracker. If
alarms have been set, tracker will enter sleep by detecting shock sensor. And tracker
sleeps by time as default.

22.2. Sleep by shock sensor

Send "sleep+password+space+shock", tracker will reply "sleep shock ok", it will
enter sleep mode if no vibration detecting, GPS module shut off, and LED will be
off too. Vibration or any operations can awake it.
14