Multicast Paging - Yealink SIP-T2 Series Administrator's Manual
Hide thumbs
Also See for SIP-T2 Series:
- Administrator's manual (1108 pages) ,
- Auto provisioning manual (241 pages) ,
- Provisioning manual (231 pages)
Table of Contents
Advertisement
4.
Select the desired value from the pull-down list of Voice Mail Display.
5.
Click Confirm to accept the change.
Multicast paging allows IP phones to send/receive Real-time Transport Protocol (RTP)
streams to/from the pre-configured multicast address(es) without involving SIP signaling.
Up to 10 listening multicast addresses can be specified on the IP phone.
Users can send an RTP stream without involving SIP signaling by pressing a configured
multicast paging key or a paging list key. A multicast address (IP: Port) should be
assigned to the multicast paging key, which is defined to transmit RTP stream to a group
of designated IP phones. When the IP phone sends the RTP stream to a pre-configured
multicast address, each IP phone preconfigured to listen to the multicast address can
receive the RTP stream. When the originator stops sending the RTP stream, the
subscribers stop receiving it.
Procedure
Configuration changes can be performed using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Configuring Advanced Features
Specify a multicast codec for the IP
phone to use for multicast RTP .
Parameter:
multicast.codec
Assign a multicast paging key.
Parameters:
295
Advertisement
Table of Contents
