System Initialization - SpectraPure The Eliminator Operator's Manual

SpectraPure

SYSTEM INITIALIZATION:

If you are setting up your system for the first time or replacing the
membrane with a different size, please follow the "Measuring Waste to
Product Water Ratio" procedure on page 11 after you do the system
hook-up below.
System Hook-Up
1. Attach the garden hose adapter (connected to the black tubing) to
your cold water source. Never run hot water (greater than 100° F
(38° C)) through the system.
2. Place the yellow concentrate (waste) tubing (with the Flow Restric-
tor inside) and the blue purified (product) water tubing into a drain.
Do not restrict flow from these lines.
3. Open the cold water supply valve. You may use pressure up to 80 psi (5.5 bar).
Check the system to ensure that all fittings are tight and leak- free
before leaving the system unattended. (If anything is leaking,
contact SpectraPure for assistance.)
Note: It is recommended that at least 2 gallons (7.57 liters) of purified
water be discarded now before collecting purified water for use. If the unit
is not used for several days, run the system for at least 10 minutes before
collecting any water. This will flush out any stale water in the system.
4. Now, follow the procedure on page 11 to adjust the Flow Restrictor.
5. Finish the installation by connecting the yellow line to a drain. The
blue line can be placed into a Rubber Maid™ trash can or set up
for automatic operation using a Liquid Level Controller (LLC-S-115 ),
(LLC-M-115) or the Auto Shut-Off Kit (ASOFK) (Shown on page 10).
SpectraPure®Inc
damage due to leaks. It is the user's responsibility to determine
SpectraPure®Inc .
E-mail: spectra@spectrapure.com Visit us on the web www.spectrapure.com
®
.
Assumes no responsibility for water
that the system is leak-free.
Fax 480.894.6109 Fax us toll-free 1.877.527.7873
9