Table of Contents
Advertisement
Ink film
You cannot receive or copy documents unless an
ink fi lm is loaded in the fax machine. The ma-
chine is therefore supplied complete with a free
ink fi lm for a few trial pages.
The symbols áéíó indicate how much ink
fi lm has already been used.
The consumption and print setting are stored
on the supplied «Plug'n'Print» card. A new
«Plug'n'Print» card therefore has to be inserted
with each new ink fi lm. The settings were made at
the factory for the initial free ink fi lm. Only this
one therefore will work without a «Plug'n'Print»
card. If this is missing or if it is not replaced
the message CHANGE
display.
If the ink fi lm is fi nished or if there is no ink
fi lm in the fax machine, the red display lamp
fl ashes, and the following message appears:
REFILL INKFILM.
1 Before loading a new ink fi lm you must remo-
ve the paper from the paper feed mechanism!
Also follow the instructions on your ink fi lm
packaging!
2 Open the fax machine by lifting the operating
panel in the middle until it clicks in place.
v Ink fi lms are available in our Télébouti-
ques.
Removing the ink film
1 Lift the rear ink fi lm roll holding both sides
with your index fi ngers upwards, in order to
remove it out of its seat and place it next to
the front ink fi lm roll.
CARD appears on the
2 Remove both ink fi lm rolls. They cannot be
reused..
3 Remove the old «Plug'n'Print» card from the
slot to the left of the ink fi lm compartment
(only the initial free ink fi lm does not have a
«Plug'n'Print» card).
Loading the ink film
1 Carefully remove the rubber rings from the
new ink fi lm. Take care not to damage the ink
fi lm.
2 Lay the large roll in the grooves provided in
the rear ink fi lm compartment. The blue too-
thed wheel must be on the right-hand side.
7
Advertisement
Table of Contents
