Table of Contents
Advertisement
5 Close the scanner cover on the left and right,
making sure it clicks into place.
6 Close the panel so that it also clicks into
place.
7 Remettez du papier (voir Installation/Mise
en place du papier).
Easylink
Easylink is used in conjunction with additional
devices connected to the same telephone line
(e.g. cordless phones). However, the additional
phone must be set to dual-tone multi-frequency
method. If your telephone connection requires
the pulse dialling method, then you would need
to briefl y reset your additional device to use it.
For more information about this, please see the
user manual for your device.
Starting fax reception
When you answer a call on the fax machine and
recognise that it is a fax (you hear a beep or no
sound) press START/COPY and hang up. The
fax will be received.
When you answer using an additional phone and
it turns out to be a fax, you can start the fax re-
ception by pressing *5 and then hang up. The
fax machine will receive the fax.
Interrupt ringing
When you answer on an additional phone and
the fax machine continues to ring, this means
that the additional phone is connected in parallel.
You can interrupt the ringing of the fax machine
by pressing **.
Changing codes
Select function 34 by pressing M, 34, and then
OK. Enter two different codes and confi rm each
code with OK. Each code should begin with *
or #.
Please note that the three Easylink codes must
be different. Otherwise on the display appears:
CODE not OK
v Only change the specifi ed codes *5 and
** if absolutely necessary!!
Service code
Function 45 Service code is used to delete some
or all of your changes to the factory settings.
This function enables you to partially or fully
reconfi gure your device. It is especially helpful if
you have modifi ed settings but fi nd that your fax
machine does not respond as expected.
v Only use this function when absolutely
necessary!
If you are satisfi ed with your changes to the fac-
tory settings you should not use this function.
After deleting some or all of your custom settings
please rerun Easy Install.
The following codes are at your disposal:
Code No. 7117
This code erases all your modifi cations to the fac-
tory settings. The fax machine will therefore react
in exactly the same way as on fi rst installation.
Code No. 7140
When you enter this code, all your entered set-
tings and data will be erased, except for:
•
received fax messages
•
stored SMS messages
•
stored short dial numbers
•
stored telephone book numbers
•
your name
31
Advertisement
Table of Contents
