Mytee 8070 -Lite Instruction Manual page 4

8070 MYTEE-LITE™
HEATER SWITCH
Release tool trigger. Turn on heater. Wait 8 – 10 minutes
for unit to pre-heat. Once heated, re-key upholstery tool
until hot water begins flowing. Once hot water is flowing,
release trigger and pre-heat an additional 4 – 5 minutes.
RECOVERY TANK DRAIN
Located at the rear of the Mytee-Lite™ is a bucket high
drain valve. Simply unscrew the tethered cap to release
the recovery water.
VACUUM SWITCH
Turn on vacuum motor and begin cleaning. For best
results make two dry passes for every wet pass.
VACUUM STACK FILTER
The Mytee-Lite's™ internal filter must be cleaned regu-
larly and is located in the recovery tank. Twist the filter
to remove then clean and replace. If the filter is torn or
damaged, replace with a new one.
4