Mytee Contractor’s Special 2000CS Instructions Manual

Hide thumbs Also See for Contractor’s Special 2000CS:

Advertisement

Instructions for
Contractor's Special
Please read before use.
Register your product
at www.mytee.com/help
13655 Stowe Dr., Poway, CA. 92064
1
2000CS
Model #
Serial #
Form # ADM-CS
3-12

Advertisement

Table of Contents
loading

Summary of Contents for Mytee Contractor’s Special 2000CS

  • Page 1 Instructions for Contractor’s Special 2000CS ™ Please read before use. Register your product at www.mytee.com/help Model # Serial # Form # ADM-CS 3-12 13655 Stowe Dr., Poway, CA. 92064...
  • Page 2 CONTRACTOR’S SPECIAL™ 2000CS 2000CS FRONT 2000CS BACK 1. Waist high controls 8. Recovery tank lid 2. 2” Male Cuff-Lynx™ 9. 3” casters 3. Female QD 10. 8” wheels 4. Solution tank 11. Rear vent 5. Front vent 12. 25’ Power cord 6.
  • Page 3 CONTRACTOR’S SPECIAL™ 2000CS ATTACH VAC & SOLUTION HOSE TO WAND 2000CS ATTACH HOSES Firmly attach hose and quick disconnect. Make sure quick discon- Attach hose cuff to end of wand tube. Attach female QD to male nects snap together firmly. Once attached to unit connect Q.D. to QD located near the wand trigger.
  • Page 4 2000CS SYSTEM MAINTAINER Add a defoamer in the recovery tank to reduce foam, prolonging Weekly flushing of the solution system with Mytee® System the life of the Contractor’s Special™ vacuum motor . Maintainer helps keep lines clean and prevents chemical build-up,...
  • Page 5 CONTRACTOR’S SPECIAL™ 2000CS PARTS & PRICING Part prices are subject to change.
  • Page 6 CONTRACTOR’S SPECIAL™ 2000CS PARTS & PRICING...
  • Page 7 CONTRACTOR’S SPECIAL™ 2000CS WIRING DIAGRAM...
  • Page 8: General Information

    If damage is evident, save the shipping carton so that it can we at Mytee Products Inc. strive to keep you on the cutting edge with superior be inspected by the carrier that delivered it. Contact the carrier immediately to file a quality and technology.
  • Page 9: Pre-Operation

    4. Filters clogged, remove filters and rinse clean with water. 8. Wait 8–10 minutes for unit to pre-heat. 5. Heater is blocked; flush out with Mytee’s system maintainer. 9. Re-key upholstery tool until hot water begins flowing. 6. If brass check valve is stuck replace valve.
  • Page 10: Warranty

    EVENT SHALL MYTEE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, PROPERTY DAMAGES, OR PERSONAL INJURIES. All limited warranties are void for, and Mytee does not warrant in any way, any prod- uct that evidences misapplication, improper installation, abuse, lack of maintenance,...

This manual is also suitable for:

Contractor’s special 2001cs

Table of Contents