Download
Share
Print this page
Mytee Contractor's Special 2002CS Instructions Manual
  1. Manuals
  2. Brands
  3. Mytee Manuals
  4. Vacuum Cleaner
  5. Contractor's Special 2002CS
  6. Instructions manual

Mytee Contractor's Special 2002CS Instructions Manual

Hide thumbs Also See for Contractor's Special 2002CS:

Advertisement

Quick Links

Download this manual
Instructions for
2002CS
Please read before use.
Register your product
at www.mytee.com/
support/register
Notes p. 11
Contractor's Special
13655 Stowe Dr., Poway, CA 92064
1
™
Model #
Serial #
Form # ADM-2002CS
11-16

Advertisement

loading

Related Manuals for Mytee Contractor's Special 2002CS

Summary of Contents for Mytee Contractor's Special 2002CS

  • Page 1: Table Of Contents

    Instructions for Contractor’s Special 2002CS ™ Please read before use. Register your product at www.mytee.com/ support/register General Information p. 2 Features p. 5 Operation p. 6 Model # Parts & Pricing p. 8 Serial # Wiring Diagram p. 10 Form # ADM-2002CS Notes p.

  • Page 2: General Information

    If damage is evident, save the shipping carton so that it can we at Mytee Products Inc. strive to keep you on the cutting edge with superior be inspected by the carrier that delivered it. Contact the carrier immediately to file a freight damage claim.

  • Page 3: Operation

    4. Filters clogged, remove filters and rinse clean with water. 8. Wait 8–10 minutes for unit to pre-heat. 5. Heater is blocked; flush out with Mytee’s system maintainer. 9. Re-key upholstery tool until hot water begins flowing. 6. If brass check valve is stuck replace valve.
  • Page 4 GENERAL INFORMATION FAQs Q: What comes standard with the Contractor’s Special™? A: The Contractor’s Special™ comes with 15’ 1-1/2” Vacuum/Solution Hose and a 12” wand and Cuff-Lynx™ reducer. Q: Where do I plug the machine in? A: The Contractor’s Special™ requires a 20A grounded circuit. Please note: GFI outlets may trip before the breaker setting.

  • Page 5: Features

    CONTRACTOR’S SPECIAL™ 2002CS FEATURES 2002CS FRONT 2002CS BACK 1. Waist high controls 5. Solution tank 9. Recovery tank 13. 25’ lighted power cord 2. 2” Male Cuff-Lynx™ 6. Front vent 10. Recovery tank drain valve 14. 12” rear wheels 3. Solution lid 7.
  • Page 6 CONTRACTOR’S SPECIAL™ 2002CS OPERATION 2002CS ATTACH HOSES ATTACH VAC & SOLUTION HOSE TO WAND Firmly attach the hose and quick disconnect. Make sure the quick Attach the hose cuff to the end of the wand tube. Attach the disconnects snap together firmly. Once attached to the unit, female quick disconnect to the male quick disconnect located near connect the quick disconnect to the upholstery tool.
  • Page 7 2002CS SYSTEM MAINTAINER Add a defoamer in the recovery tank to reduce foam, prolonging Weekly flushing of the solution system with Mytee® System the life of the Contractor’s Special™ vacuum motor. Maintainer helps keep lines clean and prevents chemical build-up,...

  • Page 8: Parts & Pricing

    CONTRACTOR’S SPECIAL™ 2002CS PARTS & PRICING Part prices are subject to change.
  • Page 9 CONTRACTOR’S SPECIAL™ 2002CS PARTS & PRICING...

  • Page 10: Wiring Diagram

    CONTRACTOR’S SPECIAL™ 2002CS WIRING DIAGRAM...

  • Page 11: Notes

    NOTES...